Securing Engine To Engine Crane
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Heavy components
- Risk of squashing
→ Wear personal protective gear.
→ Get someone to help if necessary.
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
Information
Workshop crane and transport frame
- When removing the new engine from the transport frame, it may be necessary to raise the transport frame at the side (flat jack or similar) . > Workshop crane and transport frame ]
- When removing the new engine from the transport frame, it may be necessary to safeguard the engine against lateral movement using a second worker und against scratching by covering it with a blanket.
Information
The pictures shown in this document may differ from the original.
- Pull the design cover of the throttle valve straight up and off, if it is not already removed.
- Engage one hook of the > 3033 - Suspending device in the rear transport eyebolt on the engine. Engage the other hook of the suspending device at the front of the engine. Raise the workshop crane slightly and tension the spindles slightly. The suspending device must be adjusted evenly. > Workshop crane on the V8 engine
Workshop crane on the V8 engine
- Carefully lift the engine and balance it or separate the engine from the transmission, depending on what you want to do.