Installing Rear Brake Disc

Information 

• Brake calliper screws can always be re-used if no damage can be identified. 
• Replace damaged bolts. 
• Observe different tightening specifications! 

Do not confuse left and right brake discs during assembly!

1. Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
2. Clean the flat and centring surfaces on the brake disc and wheel hub.
3. Apply a very thin coat of Optimoly TA to the centring surface on the wheel hub.
4. Installation is performed in reverse order.

   Observe specified tightening torques:

   Brake disc to wheel hub: > Tightening torque 15 (11 ftlb.) Nm 

   Brake calliper to wheel bearing housing: > Tightening torque 85 Nm (63 ftlb.) 

   Cable holder to wheel bearing housing: > Tightening torque 8 (6 ftlb.) Nm 

5. Position disc brake pads by operating the brake several times.
6. Check the brake fluid level and correct it if necessary.

> TI, 4708 ATI RECOMMENDED BRAKE FLUID TESTER (1902)