LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2014 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 60 (48 - Steering (4.8L Turbo) -- 92A - Cayenne (92A)) >> WM, 489719 Removing And Installing Reservoir >> Preliminary Work >> Removing Reservoir

Removing Reservoir

WARNING: This page is about a different variant/trim than selected.
WARNING: Caustic fluids 
  • Danger of chemical burns 
    1. Wear personal protective gear.
    2. Ensure that there is good ventilation.
    3. Avoid contact with caustic fluid.
    4. If you do come into contact, wash off immediately with plenty of warm water and contact a doctor if necessary.
NOTE: NOTIFICATION 
Pentosin 
  • Water hoses can soften and may be damaged irreparably 
    1. Always keep water hoses away from Pentosin.
    2. Water hoses that come into contact with Pentosin must be thoroughly cleaned immediately.
    3. Water hoses that have already been contaminated with Pentosin over a long time must be replaced.

Information 

Fig 1: PDCC Reservoir Components Location
G16329191Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of PDCC reservoir

PDCC reservoir
Power-steering reservoir
  1. Empty the hydraulic fluid reservoir -2-  using a suitable suction device. Use only one suction device that is used exclusively for Pentosin, not for any other fluids.
  2. Carefully disconnect hoses from the reservoir.
    1. 2.1 Open and pull back clamps -3-  using a suitable pair of pliers.
      G16329192Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Hoses at the reservoir

    2. 2.2 Place a suitable absorbent cloth underneath and use a drip pan if possible.
      G16329193Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Reservoir, suction hose 3 and return line 4

    3. 2.3 Disconnect hoses -3 and 4-  .
  3. Loosen fastening nut -4-  and remove the reservoir -1-  in an upward direction.