Subsequent Work For Removing And Installing Hydraulic Pump (Pdcc)

Information 

Pentosin in engine compartment

• The reservoir is located in the engine compartment, at the front left. 
• A dipstick with MAX/MIN markings is mounted on the cap of the reservoir. They are for a fluid level with a cold engine (approx. 20°C). 
• The MAX marking can be easily exceeded at higher temperatures. 
• Check the fluid level (Pentosin CHF 202) with the engine switched off and cold (approx. 20°C). 

1. Install air cleaner housing.

   > 242519 Removing and installing air cleaner housing - section on "INSTALLING "

2. Fit the air box for the throttle housing (Y-shaped pipe).

   > 243519 Removing and installing air box for throttle housing (Y-shaped pipe) - section on "INSTALLING "

3. Fit wheel housing liner.

   > 505619 Removing and installing front wheel housing liner - section on "INSTALLING "

4. Fit engine guard.

   > 108019 Removing and installing engine guard - section on "INSTALLING "

5. Fit the left front wheel.

   > 440519 Removing and installing wheel - section on "INSTALLING "

6. Fill the reservoir and do not exceed the MAX marking.
7. Bleed the PDCC and hydraulic power-steering system.

   > 430307 BLEEDING PORSCHE DYNAMIC CHASSIS CONTROL (PDCC)