Subsequent Work

Information 

Pentosin in engine compartment

• The reservoir is located in the engine compartment, at the front left. 
• A dipstick with MAX/MIN markings is mounted on the cap of the reservoir. They are for a fluid level with a cold engine (approx. 20°C). 
• The MAX marking can be easily exceeded at higher temperatures. 
• Check the fluid level (Pentosin CHF 202) with the engine switched off and cold (approx. 20°C). 

Before installing a new reservoir, the steering system must be flushed following repairs.

>489729 FLUSHING THE STEERING SYSTEM 

Replace the reservoir if necessary. This instruction applies to all reservoirs with or without PDCC.

>489719 REMOVING AND INSTALLING RESERVOIR 

1. Bleed the steering system and check the fluid level.

   >4890IN TEST AND ASSEMBLY WORK ON POWER STEERING 

2. Install air cleaner housing.

   > 242519 Removing and installing air cleaner housing - section on "INSTALLING "

3. Fit the air box for the throttle housing (Y-shaped pipe).

   > 243519 Removing and installing air box for throttle housing (Y-shaped pipe) - section on "INSTALLING "

4. Fit wheel housing liner.

   > 505619 Removing and installing front wheel housing liner - section on "INSTALLING "

5. Fit engine guard.

   > 108019 Removing and installing engine guard - section on "INSTALLING "

6. Fit the left front wheel.

   > 440519 Removing and installing wheel - section on "INSTALLING "