Required Tools And Parts

Parts Info: 

An auxiliary tool in the form of a screw (M14 x 1.5) and a nut (M14 x 1.5) is required for removing and installing the pulsation damper.

The following parts, for example, can be used for this (these may already be available at the Porsche dealer).

Tools: 

• Torque wrench, 6-50 Nm (4.5-37 ftlb.), e.g. > V.A.G 1331A - Torque wrench, 6-50 Nm (4.5-37 ftlb.  )
• Suitable open-ended wrench (commercially available)
• Suitable support clamp (commercially available)
• Felt-tipped pen (commercially available)