LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2014 >> Cayenne GTS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 46 (15 - Engine - Cylinder Head, Valve Drive (4.8L Turbo) -- 92A - Cayenne (92A)) >> WM, 158219 Removing And Installing Cylinder Head Cover >> Tools >> Preliminary Work

Preliminary Work

WARNING: This page is about a different variant/trim than selected.

Information 

The repair procedure is carried out at the same time for both cylinder head covers.

  1. Remove engine cover.

    > 108319 Removing and installing engine cover (design cover) - section on "REMOVING ".

  2. Remove bar ignition modules.

    > 282020 Removing and installing bar ignition modules - section on "REMOVING "

  3. Remove oil separator for cylinders 5 to 8.

    > 105519 Removing and installing oil separator - section on "REMOVING "

  4. Disconnect ground strap for cylinders 5 to 8 from the battery.

    > Refer to the appropriate service information

    and loosen the B+ transfer point and set the cables aside > Fastening screw on B+ line  .

    G16307431Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Fastening screw on B+ line

  5. Remove the relevant cross panel at the left or right.

    > WM 508119 REMOVING AND INSTALLING CROSS PANEL - section on "Removing"

scientia non olet · About LEMON Manuals