Installing Turbocharger On Cylinders 1-3

Information 

Replace sealing rings, seals and O-rings.

Information 

Before installing  the new turbocharger, remove all  the stoppers  on the turbocharger -1 and 2-  .

Ensure, in particular, that the conical rubber stopper on the connecting flange for the oil line -2-  is also removed.

In some cases, the rubber stopper, as shown in -bottom, 2-  , may be pressed slightly into the bore when the turbocharger is supplied. As a result, it is not immediately visible from the outside - particularly when fitting the oil line.

Always remove rubber stoppers before fitting the oil line  .

Fig 1: Identifying Stoppers On Turbocharger

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

• Item 1: Plastic stoppers (not always fitted - depends on the type of packaging in which the turbocharger is supplied) -1-  .
• Item 2: Rubber stopper (always fitted) -2-  .

1. Clean sealing faces between the exhaust manifold -1-  cylinder head and replace seal -2-  .
2. Fit turbocharger with exhaust manifold -1-  on cylinder head for cylinders 1 - 3.
3. Use new fastening nuts -5-  .
   Fig 2: Identifying Exhaust Manifold/Turbocharger Related Components (Cylinders 1-3)

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Tighten new fastening nuts to the specified tightening torque in the sequence -1-9-  .
   Fig 3: Identifying Exhaust Manifold/Turbocharger Nut Tightening Sequence

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Further installation is performed in reverse order.