LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2014 >> Boxster S, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 282 (13 - Engine - CRANKGEAR, Pistons -- 911 CARRERA (991)) >> WM 138219 Removing And Installing TENSIONING Roller For Drive Belt (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Installing Tensioning Roller

Installing Tensioning Roller

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit tensioning roller with screw.
    1. 1.1. Tighten the screw using the specified tool.

      → Tightening torque: 23 Nm (17 ftlb.) 

  2. Fit protection cap.
  3. Fit and tension the drive belt.

    → INSTALLING DRIVE BELT  .

scientia non olet · About LEMON Manuals