Preliminary Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Jack and raise the vehicle at the prescribed jacking points.
→ 4X00IN LIFTING THE VEHICLE .
Remove the relevant front wheel
→ 440519 REMOVING AND INSTALLING WHEEL .

→ 440519 REMOVING AND INSTALLING WHEEL WITH CENTRAL BOLT .
Remove underbody covers.
→ 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY .

→ 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY .

→ 519319 REMOVING AND INSTALLING COVER FOR CENTRE UNDERBODY .
Remove subframe -1- and tray -5- for the fuel tank.
1. 4.1. Unscrew M6 hexagon-head bolts -2- for the coolant pipes.
2. 4.2. Screw off M10 fastening nuts -3- and M10 screws -4- .
3. 4.3. Swivel the subframe -1- down and disengage the retaining straps for the fuel tank -arrows- .
4. 4.4. Remove tray for fuel tank -5- in a downward direction.
  
  Fig 1: Locating Front-Axle Subframe Mounting
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.