Installing Cover For Rear Underbody
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order to removal.
- Tighten fastening screws -2- and fastening nuts -3- using torque screwdriver Nr.89 Pos.5 . → Tightening torque: 2.7 Nm (2 ftlb.)+/-0.2 Nm (+/-0.2 ftlb.) → Tightening torque: 2.7 Nm (2 ftlb.)+/- 0.2 Nm (+/-0.2 ftlb.) .