Installing Rear Anti-Roll Bar

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Always replace fastening screws that are tightened to a torque angle.
Check anti-roll bar for corrosion and damage to the anti-roll-bar mounts.
Check suspension/stabilizer and PDCC actuator for damage and play.

Screw two anti-roll bar clamps -1 and 2- to the rear axle cross member.
Tighten screws -3- to Tightening torque 65 Nm (48 ftlb.) .

Tools: Open-end/ring wrench insert Nr.98-1 Pos.1 .

Fig 1: Identifying Rear Axle Cross Member Anti-Roll Bar Screws
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit the connecting link (suspension/stabilizer) to the anti-roll bar on both sides of the vehicle. Use new collar nuts.
Initial tightening 40 Nm (30 ftlb.) Final tightening +30°

Fig 2: Installing Anti-Roll Bar
Courtesy of PORSCHE CARS NORTH AMERICA, INC.