| Toe control arm to wheel carrier (cone) |
Lock nut, M12 x 1.5 |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Wishbone (lower control arm) to wheel carrier (cone) |
Lock nut, M12 x 1.5 |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Wishbone (lower control arm to wheel carrier) (GT4 only) |
Hexagon-head bolt, M12 x 1.5 x 90 |
Tightening torque |
120 Nm (89 ftlb.) |
|
|
| Brake air spoiler to wishbone (GT4 only) |
M6 x 10 |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Rear-axle carrier side section to body (front) |
M10 hexagon nut |
Tightening torque |
65 Nm (48 ftlb.) |
|
|
| Rear-axle carrier side section to body (rear) |
Screw, M12 x 1.5 x 80/always replace following removal |
Initial tightening |
30 Nm (22 ftlb.) |
|
|
| Rear-axle carrier side section to body (rear) |
Screw, M12 x 1.5 x 80/always replace following removal |
Final tightening |
+45° |
|
|
| Transmission mount (hydraulic mount) to rear-axle carrier side section (all versions) |
M8/differing screw lengths depending on variant (note allocation in PET) |
Tightening torque |
33 Nm |
|
|
| Brake calliper to wheel carrier |
M12 x 1.5/always use new screws following removal |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Brake hose bracket to wheel carrier |
M6 screw |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|