LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2014 >> Boxster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (42 Rear Wheel Suspension, Drive Shaft -- 911 CARRERA (991)) >> WM 429019 Removing And Installing Rear Anti-Roll Bar (Gt3, Gt3 RS) >> Removing And Installing Rear Anti-Roll Bar >> Removing Rear Anti-Roll Bar

Removing Rear Anti-Roll Bar

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove anti-roll bar -1-  .
    1. 1.1. Unscrew M8 fastening screws -4-  on the rubber mounting and remove bearing shell (left and right side).
    2. 1.2. Unscrew M10 collar nut -2-  on the connecting link (left and right side). Counter at the Internal Torx screw -3-  while doing this.
      Fig 1: Identifying Anti-Roll Bar Mount
      G09993058Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals