Adjusting Brake Light Switch
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
- Make sure that the brake pedal is in the normal position.
- Hold brake pedal in one hand and press down on the sensor in the frame with the other until the sensor surface is touching the counter plate on the brake pedal.
Information
Between the sensor and counter plate in the basic setting there is a gap of: Adjustment value 1.5 mm +/-0.5 mm .
- Press the sensor in the frame back up by one to two notches until the gap between the sensor and the counter plate has reached the dimension -X- . A feeler gauge, for example, can be used to adjust the dimension correctly.
- Perform a function test.