Technical Values
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Actual dimension | Displayed on the Tester! Actual gap dimension at the left and right measured between the shoe and drum in millimeters. | Control value | 000 mm | ||
| Required dimension | Displayed on the Tester! Required dimension between the shoe and drum in millimeters. | Control value | +2.2 mm | +/-0.3 mm | |
| Adjustment dimension | Must be calculated! Dimension that must be turned on the adjustment device in millimeters. | Control value | 000 mm | ||
| Adjustment device | 1 click corresponds to | Control value | 0.15 mm |