| Mounting plate for wheel bearing to wheel carrier |
M8 x 35 thread |
Tightening torque |
37 Nm (27 ftlb.) |
|
|
| Brake cover plate to wheel carrier |
M6x16 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Brake disc to wheel hub |
M6 screw |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Speed sensor to wheel carrier |
M6 x 16 thread |
Tightening torque |
8 Nm (6 ftlb.) |
|
|
| Cable holder to wheel carrier |
M6 thread |
Tightening torque |
10 Nm (7.5 ftlb.) |
|
|
| Brake calliper to wheel carrier |
M14 x 1.5 thread (always replace screws and lock nuts after removal.) |
Tightening torque |
140 Nm (104 ftlb.) |
|
|
| Drive shaft to wheel hub (setting 1) |
Setting 1: Before installing the wheel carrier, M22 x 1.5 thread |
Tightening torque |
130 Nm (96 ftlb.) |
|
|
| Drive shaft to wheel hub (setting 2) |
Setting 2: With wheel carrier installed, M22 x 1.5 thread |
Tightening torque |
460 Nm (340 ftlb.) |
|
|
| Tension bolt to wheel hub (vehicle without front drive shaft) |
M22 x 1.5 thread |
Tightening torque |
460 Nm (340 ftlb.) |
|
|
| Tie rod to tapered end of wheel carrier |
M12 x 1.5 thread |
Tightening torque |
85 Nm (63 ftlb.) |
|
|
| Upper wishbone to tapered end of wheel carrier |
M12 x 1.5 thread |
Tightening torque |
85 Nm (63 ftlb.) |
|
|