Removing Right Engine Mount

WARNING: This page is about a different variant/trim than selected.

WARNING: Danger of objects or loads falling down

Risk of squashing or crushing
→Se cure components to prevent them from falling down.

Information

Observe the following sequence for removing and installing the engine mounting.

Remove the primary catalytic converter on the right side.
> 267619 REMOVING AND REINSTALLING PRIMARY CATALYTIC CONVERTER (TURBO)
Undo fastening nut for the ground cable -arrow- on the front right frame carrier.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Ground cable

NOTIFICATION

Risk of straining engine parts
- Hoses, cables or other flexibly routed components can break and tear.
  → Carefully lower the engine one step at a time.
  
  → Check fitted parts at intervals for signs of strain or cracks.
Turn the wing screw on the suspending device anti-clockwise and lower the engine. > Suspending device for engine

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Suspending device for engine
Loosen the three fastening screws on the heat shield -arrows- for the final drive.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening screws on heat shield
Remove heat shield and screws. -arrow-

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing heat shield
Press against the engine mount from below -arrow- and loosen the fastening nut on the engine mount.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Loosening engine mount
Remove engine mount from the guide. -arrow-

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing engine mount (figure shows 4WD turbo engine)