Installing Right Engine Mount

Information 

The tightening specifications for the basic engine are stored centrally (→ 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES, ASSEMBLY OVERVIEWS ).

Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

1. Guide engine mount into the mounting provided for it.
2. Guide the engine mount guide pin into the groove provided for it so that it can no longer pop out.
   Fig 1: Guiding Engine Mount Guide Pin

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Press against the engine mount from below -arrow-  and tighten the fastening nuts on the engine mount (use a socket ring wrench a/f 18).
   Fig 2: Securing Engine Mount

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Position heat shield. Fit and tighten three fastening screws -arrows-  for the heat shield.
   Fig 3: Locating Fastening Screws On Heat Shield

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Turn the wing screw on the suspending device clockwise and lift the engine into its original position.
   Fig 4: Suspending Device For Engine

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Fit fastening nut for the ground cable -arrow-  on the front right frame carrier.
   Fig 5: Locating Ground Cable

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
7. Install primary catalytic converter on right side.

   → Installing Primary Catalytic Converter