Preliminary Work

Check that the following assembly preconditions have been met: 

• Oil guide housing pre-fitted with oil filter and oil/water heat exchanger.
• Examine the oil mist separator to check that seals and screw elements are pre-fitted.
• Check cylinder head cover (valve cover) to ensure that surrounding seal, seals for spark plug recesses, seal for hydraulic valve of camshaft control, hall sender for camshaft and oil filler cover are fitted.
• Intake-air distributor with seals, heat socket, screws and throttle housing inserted.
• Generator with both fitted coolant connection pieces and sheetmetal cable holders.
• Upper part of crankcase fitted on flywheel side with two water plugs. Screw plugs fitted.
• The upper part of the crankcase together with the engine support engine support 9676/1  is attached to the assembly support. Use the four screws mounting elements 9590  and tighten them. → 1001IN SECURING ENGINE ON ASSEMBLY SUPPORT (MOUNTING BRACKET)