Installing Wheel Hub

Fig 1: Identifying Tools For Pressing In Wheel Hub

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Position press-on sleeve 9694/3 under the workshop press. Fit wheel bearing housing with wheel bearing flat onto press-on sleeve 9694/3. Centre inner wheel bearing race -1-  on tool.

Fig 2: Centering Press-On Sleeve On Rear Inner Wheel Bearing Race (Rear-Axle Wheel Carrier Shown)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Place pressure piece T10205/10 -2-  flat onto the wheel hub. Make sure that the wheel bearing inner race is flat and centered on the press-on sleeve 9694/3 -3-  . Carefully press in the wheel hub until the pressure increases (check pressure gauge!).

Fig 3: Pressing In Wheel Hub

Courtesy of PORSCHE CARS NORTH AMERICA, INC.