Installing Front Bumper
NOTE:
Different tightening torque for screwing self-tapping screws into a new or existing, old thread.
- Incorrectly screwed joints
- Risk of damage to screw thread
→ Observe different tightening torques.
→ When screwing into an already shaped, old thread, first screw in screws several turns by hand, then screw in completely using a tool.
Installation is performed in reverse order to removal.
- Tighten fastening screws to the specified tightening torque Tightening torque 50 Nm (37 ftlb.) +5 Nm (+3.5 ftlb.) -7.5 Nm (-5.5 ftlb.) until secure.
- Remove tie-wrap at radiator module.