Installing Rear Connecting Link
WARNING: This page is about a different variant/trim than selected.
Information
Dimension X - lower edge of wing to centre of axle (shown as an example)
- All screws and bolts on the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on its wheels, or the wheel suspension is raised with a universal vehicle lift. Dimension -X- , from lower edge of wing to centre of axle corresponds to vehicle position. For the current height values, please refer to the adjustment values for suspension alignment
- Visually inspect all parts.
- Replace self-locking nuts.
- Replace all expansion screws (screws fitted using torque angle tightening procedure).
- Use correct tightening torques and torque angle.
- Fit the connecting link -5- on the anti-roll bar using the top fastening screw -1- .
- Raise the wheel bearing housing -3-
as far as required using a suitable jack -4-
so that the bottom fastening screw -2-
on the connecting link can be fitted easily.
Rear connecting link
- Fit the fastening screws -1, 2- for the connecting link -5- .