LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 63 (40 - Wheel Suspension Front Drive Shaft (4.8L Non Turbo) -- 92A - Cayenne (92A)) >> WM, 401519 Removing And Installing Upper Trailing Arm >> Removing Upper Trailing Arm

Removing Upper Trailing Arm

WARNING: This page is about a different variant/trim than selected.

Information 

In the event of complaints about noises from the upper trailing arm, the trailing arms on both sides of the vehicle must always be checked.

  1. Unclip ABS wire harness -1-  at the body -A-  .
    G16329294Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting point for ABS wire harness to body

  2. Remove level sensor holder from the upper axle support.

    > 431855 Replacing front level sensor - section on "Removing "

  3. Loosen fastening screws -1-  from the upper axle support -2-  .
    G16329295Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Mounting point for upper axle support

  4. Remove axle support.