Installing Sealing Ring For Crankshaft (Transmission Side)

WARNING: This page is about a different variant/trim than selected.

Information

Sealing rings become damaged as a result of improper fitting. Do not oil sealing rings on the running surface and do not pull sealing rings off the plastic sleeve.

Fig 1: Radial Shaft Seal Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Radial shaft seal

1	Radial shaft seal (use protection cap for radial shaft seal for fitting; only fit when crankcase is screwed on)
2	Crankcase
3	Crankshaft
4	Radial shaft seal (sectional view)
A	Direction of travel

Fit the sealing ring and sleeve on the tool > 9609/2 - spacer. > Pushing on sealing ring

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pushing on sealing ring
Position the centring tool > 9609/2 - spacer on the crankshaft flange. Pay attention to the centring pin when doing this. Then tighten the two fastening screws to 23 Nm (17 ftlb.). > Centring tool

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Centring tool
Position the retracting bell > 9609/1 - pressure piece and tighten the central screw (a/f 19) to 25 Nm (19 ftlb.). > Retracting bell

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Retracting bell
Loosen the retracting bell and screw it down.
Loosen the two fastening screws on the centring device and remove the tool. Remove sleeve from the tool.