Removing Control Unit For Tyre Pressure Monitoring (TPM)

→ Remove the ignition key and switch off load before disconnecting or removing load.

The TPM control unit is located on the rear axle on the left anti-roll-bar mount.

The antenna is integrated in the TPM control unit. For more information, see → 4X00IN GENERAL INFORMATION ON THE TYRE PRESSURE MONITORING SYSTEM (TPM) .

1. Disconnect electric line at the holder -1-  .
2. Release connector -2-  and disconnect it.
3. Unclip TPM control unit with holder -4-  on the back of the holder -3-  and disconnect it -arrow-  .
   Fig 1: Locating Mounting For TPM

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Take TPM control unit -1-  out of the holder -2-  (-arrow-  ).
   Fig 2: Removing TPM Control Unit With Holder

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.