LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (44 - Wheels, Tyres, Suspension Alignment (4.8L Turbo) -- 92A - Cayenne (92A)) >> WM, 449503 Complete Suspension Alignment >> Adjusting >> Calibration After Completion Of Vehicle Measurement Work

Calibration After Completion Of Vehicle Measurement Work

WARNING: This page is about a different variant/trim than selected.

Perform the required calibrations, depending on vehicle equipment, if the previous wheel alignment values (on rear and/or front axle) were changed: 

  1. Calibrate steering angle sensors.

    > WM, 456005 INITIALISING AND CALIBRATING STEERING-ANGLE SENSOR

  2. Calibrate control unit for distance measuring sensor (ACC sensor).

    > WM, 278515 ADJUSTING DISTANCE MEASURING SENSOR CONTROL UNIT

  3. Calibrate front camera.

    > WM 963825 PROGRAMMING FRONT CAMERA (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))

scientia non olet · About LEMON Manuals