LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 57 (42 - Rear Wheel Suspension Drive Shaft (4.8L Turbo) -- 92A - Cayenne (92A)) >> WM, 422119 Removing And Installing Rear Drive Shaft >> Preliminary Work

Preliminary Work

WARNING: This page is about a different variant/trim than selected.
  1. Move electric parking brake (EPB) into >>installation position<< using the Porsche System Tester. To do this, select >>Parking brake<< in the control unit overview. Select >>Drive links/checks<<>>All<<>>Move to installation position<<.
  2. Loosen the axle nut (drive shaft mounting on wheel side). (Do not remove it!) This prevents the drive shaft from slipping out when removing the wheel bearing housing. Actuate the brake while doing this.
  3. Remove wheel.

    > 440519 Removing and installing wheel - section on "REMOVING "

  4. Remove rear level sensor from the front upper wishbone.

    > 431955 REPLACING REAR LEVEL SENSOR - section on "Removing"

scientia non olet · About LEMON Manuals