LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Cayenne S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (37 - Automatic Transmission - Actuator, Housing (4.8L Turbo) -- 92A - Cayenne (92A)) >> WM, 375519 Removing And Installing ATF Pan >> Installation >> Installing ATF Pan

Installing ATF Pan

WARNING: This page is about a different variant/trim than selected.
  1. Clean all magnets in the seams of the ATF pan. Make sure to stick the magnets back on fully.
  2. Fit ATF pan with new gasket -1-  . When doing this, check that all spacer sleeves -2-  are inserted fully in the new gasket.
    G16314602Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    ATF-pan seal

  3. Tighten screws on the ATF pan in several steps and in diagonally opposite sequence. > Tightening torque 8 (6 ftlb.) Nm  --
  4. Install overflow pipe -C-  . > Tightening torque 2 Nm  --
  5. Screw in oil drain plug -A-  with a new sealing ring -B-  . > Tightening torque 20 (15 ftlb.) Nm  --
    G16314603Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Overflow pipe on ATF pan

scientia non olet · About LEMON Manuals