Tightening Specifications For Chain Housing Cover

WARNING: This page is about a different variant/trim than selected.

Information

In case of repair, two aluminum screws must be changed to steel screws -15 and 30- with aluminum washers -Arrows- .

> Refer to the appropriate service information

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Steel screw with aluminum washer

Fig 1: Chain Housing Cover Components Location With Torque Specification

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tightening specifications for chain housing cover

1-30	Tightening sequence
1-4	Aluminium screw M6 x 55
5 + 6	Aluminium screw M8 x 55
7-12	Aluminium screw M6 x 30
13 + 14	Aluminium screw M6 x 55
15	Steel screw M6 x 30 with aluminum washer 6.4 x 14 x 3 mm
14-28	Aluminium screw M6 x 30
29	Aluminium screw M6 x 55
30	Steel screw M6 x 30 with aluminum washer 6.4 x 14 x 3 mm
1-4 + 7-	Aluminium screw M6 > Initial tightening 4 Nm (3 ftlb.) > Final tightening + 90° >
14 + 16-29	Minimum torque angle + 50° > Maximum torque angle + 95° > Lower torque limit 5.2 Nm (3.8 ftlb.) > Upper torque limit 9 Nm (6.6 ftlb.)
5 + 6	Aluminium screw M8 > Initial tightening 10 Nm (7.4 ftlb.) > Final tightening + 90°
15 + 30	Steel screw M6 x 30 > Tightening torque 10 Nm (7.4 ftlb.)

Support on oil guide housing/chain housing cover

Fig 2: Chain Housing Cover On Oil Guide Housing Components Location - Only Installed On Cayenne And Panamera 6-Cylinder Engines

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Chain housing cover on oil guide housing - Only installed on Cayenne and Panamera 6-cylinder engines

1	Screw M8 x 20 > Tightening torque 23 Nm (17 ftlb.)
2	Aluminium screw M6 x 30/replace > Initial tightening 4 Nm (3 ftlb.) > Final tightening + 90°
3	Support