- On vehicles with 19-inch brake system: Fit the air guide at the anti-roll bar.
>
WM 407719 REMOVING AND INSTALLING FRONT ANTI-ROLL BAR (PDCC) (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE TURBO)
- Fit front wheel housing liners.
>
WM 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER
- Fit wheels.
>
WM 440519 REMOVING AND INSTALLING WHEEL (EXCEPT CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S HYBRID, CAYENNE S E, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))
- Install right cross panel.
>
WM 508119 REMOVING AND INSTALLING CROSS PANEL
- Fit torque support.
> 103719 Removing and installing torque support - INSTALLING
- Fit design cover on the throttle valve.
>
WM 108319 REMOVING AND INSTALLING ENGINE COVER (DESIGN COVER) (CAYENNE S, CAYENNE TURBO, CAYENNE GTS, CAYENNE TURBO S)
- Connect the battery.
>
2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
- Fill the air conditioning system.
>
WM 870317 ADDING REFRIGERANT AND REMOVING BY SUCTION (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))
- Check engine-oil level.
> 170117 CHANGING ENGINE OIL AND OIL FILTER
- Bleed the cooling system.
> 193817 Draining and filling coolant (includes bleeding) - FILLING
- Bleed the power steering.
>
WM 4890IN TEST AND ASSEMBLY WORK ON POWER STEERING (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))
- Bleed the PDCC system if necessary.
>
WM 430307 BLEEDING PORSCHE DYNAMIC CHASSIS CONTROL (PDCC) (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))
- Check ATF level and top up if necessary.
>
WM 370235 CHECKING AND TOPPING UP ATF (ALL MODELS)
- Move bonnet out of service position.
- Fit engine compartment trim panels.
>
WM 700219 REMOVING AND INSTALLING FRONT TRIM PANEL (ENGINE COMPARTMENT) (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S, CAYENNE S E-HYBRID, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))
- Perform suspension alignment.
>
WM 449503 SUSPENSION ALIGNMENT, COMPLETE (CAYENNE, CAYENNE GTS, CAYENNE TURBO S, CAYENNE S HYBRID, CAYENNE S E, CAYENNE TURBO, CAYENNE S DIESEL, CAYENNE (3.0))
- The high-pressure adaptation must be reset when replacing the engine.
- Read out DME fault memory and compare with the log you printed prior to removal.