LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Cayenne Diesel >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> 42 Rear Wheel Suspension, Drive Shafts -- 92A Cayenne >> WM 427119 Removing And Installing Rear Spring Strut (Steel Springs) (Cayenne, Cayenne GTS, Cayenne S, Cayenne S E-Hybrid, Cayenne S Diesel, Cayenne (3.0)) >> Removing Rear Spring Strut (Steel Springs With PASM)

Removing Rear Spring Strut (Steel Springs With PASM)

WARNING: Wheel bearing housing raised incorrectly
  • Risk of squashing
  • Risk of damage to components

→ Wear personal protective gear.

→ Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).

Information 

Information 

  1. Remove caps -1-  from the top screws on the spring strut at the front, under the side panel of the luggage compartment cover, using a suitable tool.
    Fig 3: Identifying Caps
    G09935479Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Loosen fastening screws -1-  on the upper spring strut, but do not remove them.
    Fig 4: Identifying Upper Spring-Strut Mount
    G09935480Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Raise the vehicle. → 4X00IN LIFTING THE VEHICLE
  4. Release electric plug connection at the upper spring-strut mount -1-  (-a-  ) and disconnect it -A-  .
    Fig 5: Removing Plug Connection For Steel Springs
    G09935481Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Secure the spring strut using a suitable jack → Lifting wheel bearing housing (example)  .
    Fig 6: Lifting Wheel Bearing Housing
    G09935482Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  6. Remove the lower spring strut -1-  from the wheel bearing housing -2-  and connecting link -4-  . To do this, loosen fastening screw -3-  .
    Fig 7: Identifying Screw Of Spring Strut And Wheel Bearing Housing
    G09935483Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  7. Remove the jack and carefully lever the spring strut -1-  out of the wheel bearing housing -2-  using a suitable tool, e.g. mounting lever.
  8. Lower the vehicle.
  9. A second mechanic is needed to hold and remove the spring strut  .

    The first mechanic unscrews the top fastening screws -1-  on the spring strut completely.

    The second mechanic holds the spring strut securely and then pulls it out of the vehicle.

    Fig 8: Identifying Upper Spring-Strut Mount
    G09935484Courtesy of PORSCHE CARS NORTH AMERICA, INC.