LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Cayenne Base, Automatic Trans >> Repair and Diagnosis >> Suspension >> Rear Suspension >> 42 Rear Wheel Suspension, Drive Shafts -- 92A Cayenne >> WM 425219 Removing And Installing Rear Wheel Bearing Housing (Wheel Carrier) (Except Cayenne, Cayenne GTS, Cayenne Turbo S, Cayenne S, Cayenne S E-Hybrid, Cayenne Turbo, Cayenne S Diesel, Cayenne (3.0)) >> Technical Values

Technical Values

Location Description Type Basic value Tolerance 1 Tolerance 2
Pressing out drive shaft -Max.- Length 10 mm +5 mm  
Drive shaft In the first step, "before installation of the wheel housing bearing", pull the drive shaft into the wheel hub and tighten to 130 Nm (96 ftlb.). Then in the second step, with the drive shaft "fitted in the vehicle", tighten it to the prescribed tightening torque! Current tightening torque under "Tightening torques for rear axle". Tightening torque +130 Nm (+96 ftlb.)    
scientia non olet · About LEMON Manuals