LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Cayenne Base, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 21 - Exhaust Gas Turbocharging -- 92A Cayenne >> WM 213919 Removing And Installing Molded Hose (V6) (Cayenne S & Cayenne GTS) >> Removing Molded Hose

Removing Molded Hose

Information 

The procedure for removing and installing is described for one side as an example. The procedure for the other side is practically identical.

  1. Remove molded hose -1-  .
    1. 1.1. Release safety clip -arrow-  and pull molded hose -1-  off the charge-air cooler -2-  .
    2. 1.2. Loosen screw-type clamp -3-  and remove molded hose -1-  from air box for the throttle valve -4-  .
      Fig 1: Identifying Molded Hose
      G09933462Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals