Subsequent Work

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Check O-rings on the plug-in couplings and replace them if necessary.
Clean plug connection and coolant hoses before assembly.
Coat O-rings and coolant hoses with Kluber Plus Gel (Part No. 000.043.205.93).
Remove stoppers before fitting the coolant lines and hoses.

Fit rear wheels. Socket-wrench insert 300 should be used.
→ 440519 REMOVING AND INSTALLING WHEEL .
Secure the drive shafts on the transmission flange. Get another person to counter at the rear wheels.
→ Installing Drive Shaft .
Fit oxygen sensor plug connections at the left and right in the engine compartment, route the lines and secure them at the retaining points.
→ Installing Oxygen Sensor Upstream Of Catalytic Converter .

→ Installing Oxygen Sensor Downstream Of Catalytic Converter .
Fill in coolant.
→ Filling Coolant 193817 Draining And Filling Coolant .
1. 4.1. Check all connections on the cooling system that were opened during removal for leaks.
Install side retaining frame (heat protection) for the rear apron.
→ 261519 REMOVING AND INSTALLING RETAINING FRAME WITH HEAT PROTECTION .
Install rear apron.
→ Installing Rear Apron .
Connect the battery.
→ WM 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
Only for vehicles with PDCC: Fill in Pentosin at the hydraulic reservoir, check the fluid level and top up if necessary.
→ 430501 CHECKING FLUID LEVEL (PDCC) .

Information
- Only for vehicles with PDCC: After installing a replacement engine, pressure must be applied to the PDCC pump via the reservoir.
Only for vehicles with PDCC: Apply pressure to the pump via the reservoir.
→ 430307 BLEEDING THE PDCC SYSTEM .
Install air cleaner housing.
→ Installing air cleaner housing .
Install rear spoiler.
→ Installing Rear Spoiler .
Fit engine-compartment blower.
→ Installing Engine-Compartment Blower .
Install air guide.
→ Installing Air Guide In Wheel Housing .
Fit all covers.
Check engine-oil level and top up with new engine oil if necessary.
→ 170101 CHECKING ENGINE-OIL LEVEL .
Bleed the cooling system according to specifications using PIWIS Tester II 9818 .
→ 190107 BLEEDING THE COOLING SYSTEM .
On Cabriolet vehicles: Install support plate.
→ 421419 REMOVING AND INSTALLING SUPPORT PLATE .
Install underbody cover.
→ Installing Cover For Centre Underbody .

→ 519419 REMOVING AND INSTALLING COVER FOR REAR UNDERBODY .
Remove protective covers.