Technical Values
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening screws for front-axle cross member, inner front | M12 x 1.5 x 50 | Tightening torque | 90 Nm (67 ftlb.) | +90° | |
| Fastening screws for front-axle cross member, outer front | M12 x 1.5 x 105 | Tightening torque | 90 Nm (67 ftlb.) | +180° | |
| Fastening nut on front-axle cross member, centre front | M12 x 1.5 | Tightening torque | 90 Nm (67 ftlb.) | +90° | |
| Fastening screws securing holder for coolant pipes to front-axle cross member | M6 x 20 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Fastening screws securing front-axle cross member and longitudinal strut to body | M12 x 1.5 x 58 | Tightening torque | 90 Nm (67 ftlb.) | + 90° | |
| Fastening nut securing longitudinal strut to body | M10 | Tightening torque | 65 Nm (48 ftlb.) | ||
| Stud securing front final drive to front-axle cross member | Stud, M10 x 105 | Tightening torque | 17 Nm (13 ftlb.) | ||
| Bracket securing front final drive to front-axle cross member | Hexagon nut, M10 | Tightening torque | 65 Nm (48 ftlb.) | ||
| Fastening screw securing universal joint at the bottom to steering gear | M8 x 30 | Tightening torque | 20 Nm (15 ftlb.) | +90° | |
| Fastening nut securing connecting link to anti-roll bar | M10 x 1.5 | Tightening torque | 40 Nm (30 ftlb.) | +30° | |
| Fastening nut securing PDCC actuator to anti-roll bar | M12 x 1.5 | Tightening torque | 50 Nm (37 ftlb.) | +50° | |
| Fastening nut securing front-axle wishbone to wheel carrier | M12 x 1.5 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Fastening nut securing tie rod to wheel carrier | M12 x 1.5 | Tightening torque | 85 Nm (63 ftlb.) | ||
| Fastening screw securing bracket for height sensor and coolant pipe to front-axle cross member | M6 x 45 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Fastening nut securing sub-frame (front-axle support) to body | M10 | Tightening torque | 65 Nm (48 ftlb.) | ||
| Fastening screw securing coolant pipes to front-axle support | M6 x 15 | Tightening torque | 10 Nm (7.5 ftlb.) |