LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Boxster S, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (42 Rear Wheel Suspension, Drive Shaft -- 911 CARRERA (991)) >> WM 421419 Removing And Installing Support Plate (CARR. S CABRIO, CARR. CABRIO, CARR. 4 CABRIO, CARR. 4S CABRIO, Turbo CABRIO, CARR. 4 GTS CABRIO, Turbo S CABRIO, Gt3, Gt3 RS) >> Installing Support Plate

Installing Support Plate

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fit support plate and position it correctly.

    Tighten fastening screws -arrows-  .

    M8 hexagon-head bolts Tightening torque 30 Nm (22 ftlb.) 

    Tapping screws Tightening torque 3 Nm (2 ftlb.) 

    Fig 1: Locating Support Plate Screws
    G09992940Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals