| Support plate to rear-axle cross member |
Screw M10 x 1.5 x 20 |
Tightening torque |
65 Nm |
|
|
| Support plate to V-strut (transverse strut rear) |
Hexagon nut M10 x 1.5 |
Tightening torque |
65 Nm |
|
|
| Diagonal brace to rear-axle carrier side section |
M10 x 1.5 hexagon nut |
Tightening torque |
65 Nm |
|
|
| Diagonal brace to body |
Combination screw, AM 10 x 35/always replace following removal |
Initial tightening |
30 Nm (22 ftlb.) |
|
|
| Diagonal brace to body |
Combination screw, AM 10 x 35/always replace following removal |
Final tightening |
+90° |
|
|