LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Boxster S, Automatic DCT Trans >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> 42 - Rear Wheel Suspension, Drive Shafts -- (981) BOXSTER/CAYMAN >> WM 420919 Removing And Installing Rear Tie Rod (Toe Control Arm) (All Models) >> Removing And Installing Rear Toe Control Arm >> Installing Rear Toe Control Arm

Installing Rear Toe Control Arm

  1. Fit toe control arm -2-  on the rear-axle carrier side section and wheel carrier. Use new lock nuts  .

    Fit toe eccentric adjuster -3-  at the position marked during removal and tighten lock nut.

    Tightening torque 110 Nm (81.5 ftlb.) 

    Tighten lock nut on wheel carrier -1-  .

    Tightening torque 85 Nm (63 ftlb.) 

    Fig 1: Securing Rear Toe Control Arm
    G10023537Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals