Checking Thickness Of Front Brake Pads

→ Only use the type-specific brake pads .

→ Replace the brake pads when the brake pad wear indicator light comes on, but no later than when there is a residual pad thickness of 2 mm on each axle.

→ Replace the brake discs on each axle upon reaching the wear limits.

Information 

• If brake pad wear is indicated by the warning light, the warning contact (sender including line and plug connection) must also be replaced  .
• Replacement of the warning contact can be avoided by replacing the brake pads no later than when the pad thickness is 2.5 mm -arrows-  .
  Fig 1: Checking Brake Pad Thickness

  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
• Warning contacts must be replaced if the core of the line is worn  .
• However, if only the plastic part of the warning contact is worn, there is no need to replace it  .

1. Visually inspect the brake pads for wear.