LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2013 >> Boxster Base, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> 94 - Lights, Lamps, Switches, Exterior -- (981) BOXSTER/CAYMAN >> WM 947019 Removing And Installing Auxiliary Brake Light (All Models) >> Removing Auxiliary Brake Light

Removing Auxiliary Brake Light

NOTE: Voltage peaks
  • Risk of damage to load or to the control unit

→ Remove the ignition key and switch off load before disconnecting or removing load.

  1. Open the rear lid.
  2. Remove the rubber sleeves on the left -1-  right -2-  and at the bottom -3-  .
    1. Left rubber sleeve in rear lid
    2. Right rubber sleeve in rear lid
    3. Centre rubber sleeve in rear lid
    Fig 1: Removing Rubber Sleeves
    G10028559Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Screw off fastening nuts of additional brake light -1-  .
    1. Additional brake light fastening nuts
    Fig 2: Removing Brake Light Fastening Nuts
    G10028560Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Using a plastic wedge -2-  , carefully lever off and disconnect the additional brake light -1-  from the rear lid along the edges and in the middle.
    Fig 3: Removing Additional Brake Light
    G10028561Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Release electric plug connection -1-  and pull it off -A-  .
    1. Electric plug connection for additional brake light
    Fig 4: Releasing Connector From Additional Brake Light
    G10028562Courtesy of PORSCHE CARS NORTH AMERICA, INC.