Installing Oil/Water Heat EXCHANGER
Information
The tightening specifications for the basic engine are stored centrally.
> Refer to 1X00IN Technical values in the appropriate service information.
/
> Refer to 2X00IN Technical values in the appropriate service information.
or
> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS
Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.
Oil/water heat exchanger, oil filter for 2WD
| 1 | Oil guide housing |
| 2 | Oil filter cover |
| 3 | Oil filter |
| 4 | Oil-filter sealing ring |
| 5 | Oil duct adapter (cannot be replaced) |
| 6 | Heat exchanger seal |
| 7 | Oil/water heat exchanger |
| 8 | Screw, M6 x 20; self-tapping screws ex-works; metric screws can also be used |
Oil/water heat exchanger, oil filter for 4WD
The oil/coolant heat exchanger is installed in reverse order to removal.
Always replace the O-rings -6- between the oil/coolant heat exchanger and the oil guide housing.
Always use the correct tightening torques
> Refer to 1001TW Tightening torques, tightening sequences, assembly overviews in the appropriate service information.