Installing Oil-Pressure Sender

Information 

The tightening specifications for the basic engine are stored centrally.

> Refer to 1X00IN Technical values in the appropriate service information. 

/

> Refer to 2X00IN Technical values in the appropriate service information. 

or

> 1001IN TIGHTENING TORQUES, TIGHTENING SEQUENCES AND ASSEMBLY OVERVIEWS

Tightening torques and assembly instructions for other assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

Component overview of oil-pressure sender 

Component overview of oil-pressure sender

1	Oil-pressure sensor adapter
2	dealing ring
3	Oil pressure sender with temperature sensor
4	Screw, M6 x 40
5	Plug
6	Sealing ring
A	Direction of travel

1. Replace sealing rings for adapter and oil-pressure sender.
2. Slide oil-pressure sender -3-  into the adapter -1-  .
3. Fit fastening screws -4-  .
4. Plug in connector for oil-pressure sender.