LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Panamera Turbo >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> 19 - Engine - Cooling -- PANAMERA (970) >> WM 194019 Removing And Installing Coolant Reservoir (Except PANAMERA Executive, PANAMERA GTS, PANAMERA Turbo S, PANAMERA 4 Executive, PANAMERA 4S Sport Edition, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Removing Coolant Reservoir

Removing Coolant Reservoir

  1. Remove connections and reservoir screws.
    Fig 1: Identifying Coolant Reservoir Components
    G09805130Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 1.1. Release and disconnect electric plug connection for the water level sensor -1-  .
    2. 1.2. Remove coolant hose -4-  .
      WARNING: Hot fluid
      • Danger of scalding

      → Avoid contact with hot fluid.

      → Wear personal protective gear.

      Information 

      After pulling off the hoses, close off all openings immediately using commercially available rubber stoppers.

      When fitting parts, do not remove stoppers until shortly before installation.

    3. 1.3. Release and pull off vent line -3-  .
    4. 1.4. Remove fastening screw -2-  .
  2. Pull reservoir forward out of the guide and remove it in a downward direction -direction of arrow-  .
    Fig 2: Removing Coolant Reservoir
    G09805131Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals