Removing Wire Harness For Front-End
Information
The number of plug connections can vary, depending on equipment.
- Connection point for wire harness for front-end
- Connector for pedestrian protection sensor
- Connector for microswitch for front lid lock
- Connector for control unit for garage door opener
- Connector for ACC
- Connector for outside temperature sensor
- Connector for pedestrian protection sensor
- Switch off ignition and remove ignition key.
- Release electric plug connection at the connection point -1- (-a- ) and disconnect it.
- Release and disconnect electric plug connections at the pedestrian protection sensors -2- and -7- .REMOVING PEDESTRIAN PROTECTION
- Release and disconnect electric plug connection at the outside temperature sensor -6- . → REMOVING OUTSIDE TEMPERATURE SENSOR
- Release and disconnect electric plug connection at the microswitch for the front lid lock -3- . → REMOVING MICROSWITCH FOR FRONT LID LOCK
- Release and disconnect electric plug connection at the control unit for the garage door opener -4- .→ REMOVING CONTROL UNIT FOR GARAGE DOOR OPENER
- Release and disconnect electric plug connection at the ACC system -5- . → REMOVING CONTROL UNIT FOR DISTANCE MEASURING SENSOR
- Remove the clips and the clip at the wire harness junction.
- Remove wire harness.