LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2012 >> Panamera S >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> 43 - Level Control, Air Suspension -- PANAMERA (970) >> WM 430955 Replacing Reservoir (PDCC) (Except PANAMERA Executive, PANAMERA 4 S Executive, PANAMERA Turbo Executive, PANAMERA Turbo S, PANAMERA Turbo S Executive, PANAMERA GTS, PANAMERA 4S Sport Edition, PANAMERA 4 Executive) >> Removing Reservoir (PDCC) >> Removing Reservoir

Removing Reservoir

WARNING: Caustic fluids
  • Danger of chemical burns

→ Avoid contact with caustic fluid.

→ Wear personal protective gear.

→ Ensure that there is good ventilation.

→ If you do come into contact, wash off immediately with plenty of warm water and contact a doctor if necessary.

NOTE: Aggressive fluids
  • Risk of damage to components and surfaces

→ Do not spill fluids.

→ In the event of contact, wash the component or surface with water.

→ Replace components that are already damaged.

Fig 1: Locating PDCC Reservoir
G09807779Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  1. Empty the reservoir using a suitable suction device. Use only one suction device that is used exclusively for Pentosin, not for any other fluids.
  2. Remove hoses -1-  .
    Fig 2: Removing Hoses
    G09807780Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 2.1. Open and pull back clamps using a suitable pair of pliers.
    2. 2.2. Place a suitable absorbent cloth underneath and use a drip pan if possible.
      NOTE: Pentosin
      • Water hoses can soften and may be damaged irreparably 

      → Always keep water hoses away from Pentosin.

      → Water hoses that come into contact with Pentosin must be thoroughly cleaned immediately.

      → Water hoses that have already been contaminated with Pentosin over a long time must be replaced.

      Information 

      • Close off PDCC lines using suitable stoppers if the reservoir is not installed immediately. 
      • Pay attention to cleanliness! 
    3. 2.3. Pull off hoses -1-  ().
  3. Unscrew fastening screws -1-  on coolant line.
  4. Unscrew fastening screws -2-  on bracket -3-  .
    Fig 3: Identifying Coolant Line, Bracket And Fasteners
    G09807781Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  5. Detach lid seal -1-  behind the reservoir.
  6. Press the reservoir and holder towards the engine compartment until the fastening screws -2-  on the reservoir are accessible.
  7. Unscrew fastening screws -2-  .
  8. Lift out the reservoir and tilt it.
    Fig 4: Identifying Lid Seal And Screws
    G09807782Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  9. Release and pull off electric plug connection -1-  .
    Fig 5: Removing Electric Plug Connection
    G09807783Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  10. Remove reservoir.