Subsequent Work

Install oil guide housing and oil pan.
> 175019 REMOVE AND INSTALL OIL PAN
Fitting new joint flange behind the vibration damper.
> 137419 REMOVE AND INSTALL CRANKSHAFT SEALING RING FOR BELT PULLEY/VIBRATION DAMPER
Check the timing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

TDC position of camshafts

Turn the engine two turns clockwise to TDC of cylinder 1 and lock the belt pulley using 9595/1 - locating pins .

Check the position of the camshafts -Arrows- . The surfaces for the camshaft adjustment must be horizontal.
1. 3.2.1 If the control chain is still in the same position as it was during removal, remove 9595/1 - locating pins and continue with Step 4.
2. 3.2.2 Only set the timing if the control chain has jumped.
  > 150516 SETTING THE TIMING FOR CAMSHAFTS
Fit vibration damper.
> 137619 REMOVE AND INSTALL BELT PULLEY (VIBRATION DAMPER)
Install both valve covers.
> 158219 REMOVE AND INSTALL CYLINDER HEAD COVER
Mount drive belt. For details, see
> 137819 REMOVING AND INSTALLING DRIVE BELT

Fit coolant hoses in front of the chain housing cover. Don't forget the holder. Coolant return line on turbo, for example

Fig 1: Coolant Return Line Components Location (Turbo)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant return line on turbo, for example

1	Connection piece on alternator
2	Connection piece screw
3	Screw, M6 x 20
4	Coolant return line
5	Coolant return hose assembly
6	Bracket
7	M6 screw Aluminium screw; always use new aluminium screws
8	Clip

Filling engine oil. For details, see
> 170117 DRAINING AND FILLING ENGINE OIL (CHANGING ENGINE OIL)
Flange the transmission.
> Refer to 343527 Removing and mounting transmission in the appropriate service information.

or

> WM 373427 REMOVING AND MOUNTING PORSCHE DOPPELKUPPLUNG (PDK) (EXCEPT PANAMERA S E-HYBRID, PANAMERA S HYBRID, PANAMERA EXECUTIVE, PANAMERA GTS, PANAMERA TURBO S,)
Installing engine.
> 100119 REMOVE AND INSTALL ENGINE