Removing Pulley (Vibration Balancer)

Counter-hold tool 9679/3 with the rectangular tube from holding wrench 9732 must be inserted into the vibration damper and turned until it locks. → see Fig 1

Fig 1: Inserting Counter-Hold Tool In Vibration Damper
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit the large torque wrench or T-piece -2- and use a tubular handle if necessary -1- .
1. 2.1. Undo the central screw of the damper. Do not use the screw again.
2. 2.2. Use a tubular handle -1- if necessary.
  NOTE:
  Incorrect handling of tools
  - Risk of damage to the body
  → Only use tools approved by Porsche.
  
  → Always ensure that the tool is seated correctly.
  
  → Protect the body and interior of the vehicle from damage with protective covers.
  
  → Cover delicate components with cardboard or sheetmetal panels.
  
  Information
  
  Protect the radiator fins using cardboard or a sheetmetal panel to prevent damage.
  
  Cover wing and peripheral parts to protect them.
3. 2.3. Loosening torque is very high
  
  Fig 2: Identifying Vibration Damper Components
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Remove central screw and pull vibration damper down and forward. → see Fig 3

Fig 3: Identifying Vibration Damper
Courtesy of PORSCHE CARS NORTH AMERICA, INC.