Removing Front Three-Point Belt
- Triggering of seat-belt pretensioner unit
→ Observe safety regulations for handling seat-belt pretensioner units. → 6X00IN HANDLING AND REPLACING AIRBAG AND SEAT-BELT PRETENSIONER UNITS
→ Observe disposal regulations for seat-belt pretensioner units. → 6X00IN DISPOSAL OF AIRBAG AND SEAT-BELT PRETENSIONER UNITS
→ After disconnecting the battery, wait 1 minute before disconnecting the seat-belt pretensioner unit.
→ Remove ignition key and disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier is avoided. → 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
→ If removed for an extended period, the seat-belt pretensioner unit must be stored in a safe place.
→ Transport the seat-belt pretensioner unit in such a way that the seat belt can retract safely if it is actuated.
- Unlock retaining clip on the seat belt mount using a suitable screwdriver -arrow A- .
- Push the seat belt mount over the retaining pin -arrow B- until the locking lug under the retaining pin loosens the clip.
- Remove seat belt mount from the retaining pin -arrow A- and pull out the seat belt -arrow B- .
- Unscrew fastening screw -1- on the top belt lug and remove it -arrow A- .
- Remove seat belt.
- 5.1. Turn the top belt lug and push it downwards behind the retaining bar. Turn the top belt lug and push it downwards behind the retaining bar.
- 5.2. Pull out seat-belt buckle with seat belt mount in a downward direction. Pull out seat-belt buckle with seat belt mount downwards, behind the retaining bar.
- Release locking mechanism on electric plug connection -arrow a- and disconnect electric push-on connector -1- (-arrow A- ).
- Unscrew fastening screw -1- on the belt roller and remove it -arrow A- .
- Remove belt roller in an upward direction -arrow B- .