Removing Right Engine Mount

→ Secure components to prevent them from falling down.

Information 

Observe the following sequence for removing and installing the engine mounting.

• Remove right engine mounting 
• Remove left engine mounting 
• Install left engine mounting 
• Install right engine mounting 

1. Remove the primary catalytic converter on the right side  .

   → 267619 REMOVING AND INSTALLING PRIMARY CATALYTIC CONVERTER (TURBO)

2. Undo fastening nut for the ground cable -arrow-  on the front right frame carrier.
   Fig 1: Locating Ground Cable

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   NOTE: Risk of straining engine parts

   • Hoses, cables or other flexibly routed components can break and tear.

   → Carefully lower the engine one step at a time.

   → Check fitted parts at intervals for signs of strain or cracks.

3. Turn the wing screw on the suspending device anti-clockwise and lower the engine. → Suspending device for engine 
   Fig 2: Suspending Device For Engine

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Loosen the three fastening screws on the heat shield -arrows-  for the final drive.
   Fig 3: Locating Fastening Screws On Heat Shield

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Remove heat shield and screws. -arrow- 
   Fig 4: Removing Heat Shield

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Press against the engine mount from below -arrow-  and loosen the fastening nut on the engine mount.
   Fig 5: Loosening Engine Mount

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
7. Remove engine mount from the guide. -arrow- 
   Fig 6: Removing Engine Mount (4WD Turbo Engine)

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.